HP Designjet 4500 Printer series - Manual (Page 60)

Get started
The following topics describe how to assemble your new printer (also described in the Printer
assembly document).
Because some of the components of the printer are bulky, you may need up to four people to lift
them. You will also need at least 3 × 5 m (10 × 16 ft) of empty floor space, and about four hours.
NOTE If you have bought the HP Designjet 4500 Scanner, you can reduce the overall setup
time by assembling the scanner first and then switching it on. The scanner will take one hour
to warm up.
Before you start unpacking, consider where you are going to put the assembled printer. You should
allow some clear space at the back and at the front of the printer. The recommended clearances are
shown in the illustration below.
Unpack the printer
1. Cut the strap around the boxes carefully, as the boxes may fall as soon as the strap is cut.
2. Remove all the upper four plastic handles from both sides of the box (two each side). Carefully
fold the two side lids up onto the top of the box as shown, then remove the two boxes.
3. The symbols on the boxes identify the contents. Refer to the table below:
Symbol on box Contents of box
Printer body
46 Chapter 3 How do I... (printer assembly topics) [4500] ENWW
How do I... (printer
assembly topics) [4500]