HP Designjet 4500 Printer series - Manual (Page 32)

2. Pull open the protective plastic from the base of the printer. Please ensure that there is a three-
meter space clear of obstructions to the rear of the printer.
Remove the two desiccant bags from the printer.
3. In this step, make sure you position the stand pins in the holes in the center of the printer body
brackets.
Lift the stand assembly onto the printer body. The anti-slip material should face to the rear of
the printer.
4. Fix the right side of the stand to the printer using one screw. Make sure that the screw is fully
tightened.
18 Chapter 2 How do I... (printer assembly topics) [4000] ENWW
How do I... (printer
assembly topics) [4000]