Roll detached from spindle, No paper visible, Load a single sheet [4000 – HP Designjet 4500 Printer series User Manual
Page 128: Roll detached from spindle no paper visible
5.
Press the spindle lever (2) down and remove the roll from the printer, pulling out the right-hand
end first. Do not insert your fingers into the spindle supports during the removal process.
Roll detached from spindle
If the end of the roll is visible but no longer attached to the spindle:
1.
If you have already selected Paper unload at the front panel, press the Cancel key to cancel
that procedure.
2.
Lift the paper load lever. If the front panel displays a warning about the lever, ignore it.
3.
Pull out the paper from the front of the printer.
4.
Press the spindle lever down and remove the empty spindle from the printer, pulling out the
right-hand end first. Do not insert your fingers into the spindle supports during the removal
process.
5.
Lower the paper load lever.
6.
If the front panel is displaying a warning message, press the Select key to clear it.
No paper visible
If the end of the roll has entirely disappeared into the printer:
1.
Press the Form Feed and Cut key on the front panel, and the remaining paper will be ejected.
2.
Press the spindle lever down and remove the empty spindle from the printer, pulling out the
right-hand end first. Do not insert your fingers into the spindle supports during the removal
process.
Load a single sheet [4000]
NOTE This topic applies to the HP Designjet 4000 Printer series only.
Any loaded roll must be unloaded before loading a sheet. See Unload a roll from the printer [4000].
114
Chapter 6 How do I... (paper topics)
ENWW
How do
I... (paper topics)