HP Designjet 4500 Printer series - Manual (Page 139)

6. Remove the empty spindle from the printer, pulling out the right-hand end first. Do not insert
your fingers into the spindle supports during the removal process.
7. Lower the drive pinch and paper load levers.
8. If the front panel is displaying a warning message, press the Select key to clear it.
No paper visible
If the end of the roll has entirely disappeared into the printer:
1. Press the Form Feed and Cut key on the front panel, and the remaining paper will be ejected.
2. Lift the drawer upwards a little, then pull it towards you.
3. Remove the empty spindle from the printer, pulling out the right-hand end first. Do not insert
your fingers into the spindle supports during the removal process.
Trim the paper with the manual cutter [4500]
NOTE This topic applies to the HP Designjet 4500 Printer series only.
The manual cutter can be used to trim the leading edge of the paper if it is dirty or uneven. This helps
to avoid paper jams during loading.
1. Open the drawer of the roll that you intend to trim.
2. With your left hand, pull the leading edge of the paper over the top of the roll and then down in
front of the drawer.
3. Find the manual cutter on the right side of the drawer.
ENWW Trim the paper with the manual cutter [4500] 125
How do I...
(paper topics)