Campbell Scientific CR1000 Measurement and Control System - Manual (Page 21)

Table of Contents
21
Figure 104: Current limiting resistor in a rain gage circuit ......................... 325
Figure 105: Control port current sourcing................................................... 328
Figure 106: Relay driver circuit with relay ................................................. 329
Figure 107: Power switching without relay ................................................ 329
Figure 108: PakBus network addressing..................................................... 352
Figure 109: Flat Map................................................................................... 356
Figure 110: Tree Map.................................................................................. 357
Figure 111: Configuration and wiring of PakBus LAN .............................. 358
Figure 112: DevConfig Deployment | Datalogger tab................................. 359
Figure 113: DevConfig Deployment | ComPorts Settings tab..................... 359
Figure 114: DevConfig Deployment | Advanced tab .................................. 360
Figure 115: LoggerNet Network-Map Setup: COM port............................ 361
Figure 116: LoggerNet Network-Map Setup: PakBusPort.......................... 362
Figure 117: LoggerNet Network-Map Setup: Dataloggers ......................... 362
Figure 118: Using the keyboard / display ................................................... 401
Figure 119: Displaying data with the keyboard / display............................ 402
Figure 120: Real-time tables and graphs..................................................... 403
Figure 121: Real-time custom..................................................................... 404
Figure 122: Final-storage tables.................................................................. 405
Figure 123: Run/Stop Program ................................................................... 406
Figure 124: File display .............................................................................. 407
Figure 125: File: edit................................................................................... 408
Figure 126: PCCard (CF Card) display....................................................... 409
Figure 127: Ports and status ........................................................................ 410
Figure 128: Settings .................................................................................... 410
Figure 129: Configure display..................................................................... 411
Figure 130: Loosening thumbscrews .......................................................... 418
Figure 131: Pulling edge away from panel ................................................. 419
Figure 132: Removing nuts to disassemble canister ................................... 419
Figure 133: Remove and replace battery..................................................... 420
Figure 134: Potentiometer R3 on PS100 and CH100 Charger /
Regulator.............................................................................................. 442
Figure 135: DevConfig terminal emulator tab ............................................ 445
Figure 136: Accuracy, Precision, and Resolution ....................................... 472
List of Tables
Table 1. Single-Ended and Differential Input Channels ............................... 37
Table 2. Pulse-Input Channels and Measurements........................................ 39
Table 3. PC200W EZSetup Wizard Example Selections.............................. 45
Table 4. Current Source and Sink Limits ...................................................... 84
Table 5. Operating System Version in which Preserve Settings via
Program Send Instituted......................................................................... 96
Table 6. Program Send Options that Reset Memory*................................. 111
Table 7. Data Table Structures.................................................................... 111
Table 8. Formats for Entering Numbers in CRBasic .................................. 112
Table 9. CRBasic Program Structure .......................................................... 113
Table 10. Data Types .................................................................................. 119
Table 11. Predefined Constants and Reserved Words................................. 123
Table 12. TOA5 Environment Line ............................................................ 126
Table 13. Typical Data Table...................................................................... 127
Table 14. DataInterval() Lapse Parameter Options..................................... 130
Table 15. Task Processes ............................................................................ 133
Table 16. Pipeline Mode Task Priorities..................................................... 134
Table 17. Program Timing Instructions ...................................................... 135
Table 18. Rules for Names.......................................................................... 140