Campbell Scientific CR1000 Measurement and Control System - Manual (Page 53)

Section 4. Quickstart Tutorial
53
4.2.5.4 Procedure: (PC200W Step 6)
6. Click on the Collect Data tab. From this window, data are chosen to be
collected as well as the location where the collected data will be stored.
Figure 22: PC200W Collect Data tab
4.2.5.5 Procedure: (PC200W Steps 7 to 9)
7. Click the OneMin box so a check mark appears in the box. Under What to
Collect, select New data from datalogger. This selects the to be collected.
8. Click on Collect. A dialog box will appear prompting for a filename. Click
Save to accept the default filename of CR1000_OneMin.dat. A progress bar
will appear as data are collected, followed by a Collection Complete
message. Click OK to continue.
9. To view the data, click on at the top of the window to open the View
utility.