Campbell Scientific CR1000 Measurement and Control System - Manual (Page 536)

Appendix B. Status Table and Settings
536
Table 121. Status-Table Fields and Descriptions
Fieldname Description Variable Type Default Range Edit? Info Type
CentralRouters 18
Array of (8) PakBus
addresses for central routers.
Integer array of 8 0 Yes Config PB
Beacon
Array of Beacon intervals (in
seconds) for comms ports.
Aliased to:
BeaconRS-232
BeaconME
BeaconSDC7
BeaconSDC8
BeaconSDC10
BeaconSDC11
BeaconCOM1
BeaconCOM2
BeaconCOM3
BeaconCOM4
Integer array of 9 0
0 - approx.
65,500
Yes Config PB
Verify
Array of verify intervals (in
seconds) for com ports.
Aliased to
VerifyRS-232
VerifyME
VerifySDC7
VerifySDC8
VerifySDC10
VerifySDC11
VerifyCOM1
VerifyCOM2
VerifyCOM3
VerifyCOM4
Integer array of 9 0
0 - approx.
65,500
Status
MaxPacketSize
Maximum number of bytes
per data collection packet.
_ 1000
USRDriveSize
Configures the USR: drive. If
0, the drive is removed. If
non-zero, the drive is created.
Integer 0 8192 Min Yes Mem
IPInfo
Indicates current parameters
for IP connection.
String
IPAddressEth
Specifies the IP address for
the Etnernet interface. If
specified as zero, the address,
net mask, and gateway are
configured automatically
using DHCP.
Entered as String /
Stored as 4 byte
0.0.0.0
All valid IP
addresses
Yes
IPGateway
Specifies the address of the
IP router to which the
CR1000 will forward all non-
local IP packets for which it
has no route.
Entered as String /
Stored as 4 byte
0.0.0.0
All valid IP
addresses
Yes