Campbell Scientific CR1000 Measurement and Control System - Manual (Page 535)

Appendix B. Status Table and Settings
535
Table 121. Status-Table Fields and Descriptions
Fieldname Description Variable Type Default Range Edit? Info Type
CommActive 15
Array of Boolean values
telling if communications are
currently active on the
corresponding port.
CommActiveRS-232
CommActiveME
CommActiveCOM310
CommActiveSDC7
CommActiveSDC8
CommActiveSDC10
CommActiveSDC11
CommActiveCOM1
CommActiveCOM2
CommActiveCOM3
CommActiveCOM4
Boolean array of 9
False, except
for the active
COM
True or False Status
CommConfig
16
Array of values telling the
configuration of comm ports.
Aliased to:
CommConfigRS-232
CommConfigME
CommConfigCOM310
CommConfigSDC7
CommConfigSDC8
CommConfigSDC10
CommConfigSDC11
CommConfigCOM1
CommConfigCOM2
CommConfigCOM3
CommConfigCOM4
Integer array of 9
RS-232
through
SDC8
= 4 (Enabled)
COM1,
COM2,
COM3, or
COM4 = 0
(Disabled)
0 = Program
Disabled
4 = Program
Enabled
Ports toggled
through program
control
(SerialOpen /
SerialClose).
RS-232 is
always
hardware-
enabled.
Config
Baudrate 17
Array of baud rates for
comms. Aliased to:
BaudrateRS-232
BaudrateME
BaudrateSDC
BaudrateCOM1
BaudrateCOM2
BaudrateCOM3
BaudrateCOM4
Integer array of 9
RS-232=-
115200 ME-
SDC8 =
115200
COM1,
COM2,
COM3, or
COM4 = 0
(Disabled)
0 = Auto
1200
2400
4800
9600
19.2k
38.4k
57.6k
115.2k
Yes, can also
use SerialOut
instruction to
setup.
Config
IsRouter
Is the CR1000 configured to
act as router?
Boolean False 0 or 1 Yes Config PB
PakBusNodes (p. 433)
Number of nodes
(approximately) that will
exist in the PakBus network.
This value is used to
determine how much
memory to allocate for
networking (see
CommsMemFree(2)
(p. 433) ).
Integer 50 >=50 Yes Config PB