Figure 37: devconfig settings editor, P. 97 – Campbell Scientific CR1000 Measurement and Control System User Manual
Page 97
Advertising
Section 7. Installation
97
Clicking the Factory Defaults button on the settings editor will send a command
to the device to revert to its factory default settings. The reverted values will not
take effect until the final changes have been applied. This button will remain
disabled if the device does not support the DevConfig protocol messages.
Clicking Save on the summary screen will save the configuration to an XML file.
This file can be used to load a saved configuration back into a device by clicking
Read File and Apply.
Figure 37: DevConfig Settings Editor
Advertising