Allied Telesis AT-S83 - Manual (Page 126)

Chapter 6: Configuration Terminal Mode Commands
126
IP RADIUS SOURCE-INTERFACE
Syntax
ip radius source-interface HOSTNAME PORT
no ip radius source-interface
Parameters
HOSTNAME Specifies the radius client in the dotted IP address or
the hostname format.
PORT Specifies the radius client port number. The default
port number is 1812.
Description
Use the IP RADIUS SOURCE-INTERFACE command to set the local
address (sent in packets) to the RADIUS client.
Use the no form of this command to clear the local address.
Command Mode
Configuration Terminal mode
Examples
The following command sets the RADIUS client to a port number of 1811.
switch#configure terminal
switch(config)#ip radius source-interface myhost 1811
Related Commands
none