Allied Telesis AT-S83 - Manual (Page 282)

Chapter 14: Routing Information Protocol (RIP) Commands
282
IP RIP RECEIVE VERSION
Syntax
ip rip receive version 1|2
no ip rip receive version 1|2
Parameters
1 Specifies the acceptance of RIP version 1 packets.
2 Specifies the acceptance of RIP version 2 packets.
Description
Use the IP RIP RECEIVE-VERSION command to receive a specified
version of RIP packets on an interface. This command overrides the
setting of the VERSION command.
Use the no form of this command to use the setting specified with the
VERSION command.
Command Mode
Interface mode
Example
The following command configures interface 5 to receive RIP version 1
packets:
switch#configure terminal
switch(config)#interface xe5
switch(config-if)#ip rip receive version 1
Related Commands
“VERSION” on page 308