Allied Telesis AT-S83 - Manual (Page 267)

AT-S83 Management Software Command Line Interface User’s Guide
267
SPANNING-TREE RSTP ENABLE
Syntax
spanning-tree rstp enable
no spanning-tree rstp enable
Parameters
none
Description
Use the SPANNING-TREE RSTP ENABLE command to enable RSTP on
the switch. After you have specified RSTP, all subsequent commands
spanning tree commands apply to RSTP. Use the no form of this
command to disable RSTP on the switch.
To make RSTP the active spanning tree mode and enable it on the switch,
use the SPANNING TREE MODE command.
Command Mode
Configuration Terminal mode
Example
The following commands enable RSTP on the switch:
switch#configure terminal
switch(config)#spanning-tree rstp enable
Related Commands
“SPANNING-TREE MODE” on page 257