Allied Telesis AT-S83 - Manual (Page 26)

Chapter 1: Getting Started with the Command Line Interface
26
Key Chain Mode
Command
The Key Chain mode is used to assign an authentication key. Use the
KEY CHAIN command to access this mode from the Configuration
Terminal mode. Within this mode, you can assign a key number.
For a list of commands that can be accessed from the Key Chain mode,
see Table 10. The commands in this mode are in Chapter 14, “Routing
Information Protocol (RIP) Commands” on page 269.
Table 10. Key Chain Mode Commands
Command Description
IP RIP AUTHENTICATION KEY-CHAIN Specifies the name of the
authentication key chain.
KEY Assigns a key number.
KEY CHAIN Accesses the Key Chain
mode.