Allied Telesis AT-S83 - Manual (Page 297)

AT-S83 Management Software Command Line Interface User’s Guide
297
ROUTE
Syntax
route A.B.C.D/M
no route A.B.C.D/M
Parameters
A.B.C.D/M Specifies the IP address prefix and length.
Description
Use the ROUTE command to add a static RIP route. This command is
most commonly used for debugging purposes and is not displayed in the
kernel routing table. After adding the RIP route, you can check the route in
the RIP routing table.
Use the no form of this command to disable this function.
Command Mode
Router mode
Example
The following commands configure static RIP route with an IP address and
a mask of 10.10.10.11/8.
switch# configure terminal
switch(config)# router rip
switch(config-router)# route 10.10.10.11/8
Related Commands
“CLEAR IP RIP ROUTE” on page 271, “SHOW IP RIP” on page 301