Snmp-server enable traps snmp – Allied Telesis AT-S83 User Manual
Page 161
AT-S83 Management Software Command Line Interface User’s Guide
161
SNMP-SERVER ENABLE TRAPS SNMP
Syntax
snmp-server enable traps snmp link IFNAME
no snmp-server enable traps link IFNAME
Parameters
link
Enables link traps.
IFNAME
Specifies the name of the interface.
Description
Use the SNMP-SERVER ENABLE TRAPS SNMP command to enable
SNMP traps that are sent from a specified interface on the switch to a trap
host. If no interface is specified, this command enables SNMP traps on all
interfaces. Use the no form of this command to disable SNMP traps.
Command Mode
Configuration Terminal mode
Examples
The following command enables the SNMP link traps on interface 7:
switch#snmp-server enable traps snmp link xe7
The following command enables the SNMP link traps on all of the
interfaces:
switch#snmp-server enable traps snmp link
Related Commands
“SHOW RUNNING-CONFIG” on page 64