Allied Telesis AT-S83 - Manual (Page 201)

AT-S83 Management Software Command Line Interface User’s Guide
201
SWITCHPORT ACCESS VLAN
Syntax
switchport access vlan VLANID <2-4094>
no switchport access vlan VLANID
Parameters
VLANID Specifies a VLAN ID. Enter a value from 2 to 4094.
Description
Use the SWITCHPORT ACCESS VLAN command to change the default
VLAN for an interface. Use the no form of this command to remove a
previously created VLAN with the specified VLAN ID.
Note
The default VLAN ID is 1. Do not use a VLAN ID of 1 due to
interoperability issues.
Command Mode
Interface mode
Example
The following commands sets the default VLAN to 3 on interface 6:
switch#configure terminal
switch(config)#interface xe6
switch(config-if)#switchport access vlan 3
Related Commands
SHOW VLAN