Allied Telesis AT-S83 - Manual (Page 221)

AT-S83 Management Software Command Line Interface User’s Guide
221
DOT1X TIMEOUT RE-AUTHPERIOD
Syntax
dot1x timeout re-authperiod SECS
Parameters
SECS Indicates the number of seconds between
reauthorization attempts. Choose a value between is
from 1 to 4,294,967,295 seconds. The default value is
3,600 seconds.
Description
Use the DOT1X TIMEOUT RE-AUTHPERIOD command to specify the
time, in seconds, between reauthorization attempts by the switch (the
authenticator).
Command Mode
Interface mode
Example
In the following example, the reauthorization time is set to 120 seconds on
interface 5:
switch# configure terminal
switch(config)# interface xe5
switch(config-if)# dot1x timeout re-authperiod 120
Related Commands
none