Allied Telesis AT-S83 - Manual (Page 79)

AT-S83 Management Software Command Line Interface User’s Guide
79
SHOW INTERFACE
Syntax
show interface (IFNAME)
Parameters
IFNAME Specifies the name of an interface. This is an optional
parameter.
Description
Use the SHOW INTERFACE command to display the configuration and
status of an interface. If you do not specify an interface, this command
displays the status of all the interfaces.
Command Mode
Privileged Executive mode
Example
The following is an example of the SHOW INTERFACE command on
interface 1 and the sample output:
switch#show interface xe1
Interface xe1
Scope: both
Hardware is Ethernet, address is 0004.2104.0801 (bia
004.2104.0801)
index 2001 metric 1 mtu 1500 duplex-full arp ageing
timeout 0
speed unknown mdix mdi
<UP,BROADCAST,MULTICAST>
VRF Binding: Not bound
VRF Binding: not bound
input packets 00, bytes 00, dropped 00, multicast
packets 00
output packets 00, bytes 00, multicast packets 00
broadcast packets 00
Related Commands
none