Allied Telesis AT-S83 - Manual (Page 67)

67
Chapter 5
Privileged Executive Mode Commands
This chapter provides a description of the commands that are available
from the Privileged Executive mode. These commands permit basic
configuration of the switch and access to the 802.1x protocol. In addition,
you can display the current configuration of the switch. From this protocol,
all of the View mode commands (with the exception of the ENABLE
command) are available.
This chapter contains the following commands:
ˆ “BOOT CONFIG-FILE” on page 69
ˆ “CONFIGURE TERMINAL” on page 70
ˆ “COPY” on page 71
ˆ “DISABLE” on page 72
ˆ “DOWNLOAD A.B.C.D FILE-NAME” on page 73
ˆ “DOWNLOAD SERIAL” on page 74
ˆ “DOT1X INITIALIZE” on page 75
ˆ “PING IP” on page 76
ˆ “SHOW BOOT” on page 77
ˆ “SHOW FLOWCONTROL INTERFACE” on page 78
ˆ “SHOW INTERFACE” on page 79
ˆ “SHOW INTERFACE STATUS ALL” on page 80
ˆ “SHOW NTP ASSOCIATIONS DETAIL” on page 81
ˆ “SHOW NTP STATUS” on page 82
ˆ “SHOW STATIC-CHANNEL-GROUP” on page 83
ˆ “SHOW SYSTEM STATUS” on page 84
ˆ “SHOW VERSION” on page 85
ˆ “SYSTEM REBOOT” on page 86
ˆ “TELNET” on page 87
ˆ “TERMINAL” on page 88
ˆ “UNDEBUG ALL” on page 89
ˆ “UNDEBUG DOT1X” on page 90
ˆ “UNDEBUG OSPF EVENTS” on page 91
ˆ “UNDEBUG OSPF IFSM” on page 92