Allied Telesis AT-S83 - Manual (Page 301)

AT-S83 Management Software Command Line Interface User’s Guide
301
SHOW IP RIP
Syntax
show ip rip
Parameters
none
Description
Use the SHOW IP RIP command to display RIP routes. To modify the lines
displayed, use “|” the output modifier token. To save the output to a file,
use “>,” the output redirection token.
Command Mode
View and Privileged Executive modes
Example
The following command displays the RIP routing table with the destination
network, nexthop, and metric to reach it:
switch#show ip rip
Codes: R - RIP, Rc - RIP connected, RS - RIP static,
K - Kernel, C - Connected, S - Static, O - OSPF,
I - IS-IS, B - BGP
See the Table 16 for the definitions of the previous example.
Network Next Hop Metric From If Time
Rc 10.10.10.0/24 1 vlan1
R 10.10.11.0/24 10.10.10.38 2 10.10.10.33 vlan1 02:42
Table 16. SHOW IP RIP
Heading Definition
Network Specifies the routing code (see list above) as
well as the IP address and subnet mask of the
network.
Next Hop Specifies the IP address of the next hop.
Metric Indicates the number of hops.