Allied Telesis AT-S83 - Manual (Page 224)

Chapter 11: 802.1x Access Control Commands
224
DOT1X TIMEOUT TX-PERIOD
Syntax
dot1x timeout tx-period SECS <1-65535>
no dot1x timeout tx-period SECS
Parameters
SECS Specify the period between successive request ID
attempts. Choose a value between 1 and 65,535
seconds.
Description
Use the DOT1X TIMEOUT TX-PERIOD command to set the interval
between successive attempts to request an ID. Use the no form of this
command to reset the command to its default value. The default timeout is
30 seconds.
Command Mode
Interface mode
Example
The following commands set the timeout interval to 60 seconds on
interface 3:
switch# configure terminal
switch(config)# interface xe3
switch(config-if)# dot1x timeout tx-period 60
Related Commands
none