Bernina dcet 2500 - Manual (Page 30)


1999 BERNINA Of America
Section B - page12
THE ELASTICATOR
Feet-ures Unit ____pg.___
Instruction Manual for Elasticator
Bernette
 Advanced Guide Workbook pg.___
Serger Library – Tips and Tricks
Additions
• Turn the Stitch Selection Dial to “B” on the Stitch Selection Panel.
• Thread the serger for a 4-thread Overlock stitch.
• Adjust Stitch Length to 4.
• Adjust the Presser Foot Pressure lever to “H” to increase the pressure.
• Remove the Presser Foot – Instruction Manual page___.
• Following the directions in the Instruction Manual for Elasticator, attach the
Presser Foot.
• Locate and raise the Roller Guide in the front of the Presser Foot.
• Touch the Needle Stop Button to lower the Needles. (This lowers the Feed Dog.)
• Raise the Presser Foot and insert the elastic through the slot and under the
Presser Foot until it touches the Needles.
• Lower the Presser Foot and serge a few stitches to catch and straighten the
elastic along the right edge of the slot. Press the Needle Stop Button to lower
the Needles.
• Lower the Roller Guide.
• Using the small screwdriver, adjust the Guide Plate on the Presser Foot to the
width of the elastic.
• Locate the Pressure Adjustment Set Screw (on the top of the Roller Guide) and
turn the screw counterclockwise to completely loosen the pressure on the roller.
• Place the fabric under the Presser Foot and begin serging.
• Slowly tighten the Pressure Adjustment Set Screw to increase the pressure on
the roller and stretch the elastic. Note – do not over tighten the screw.
Excessive pressure on the elastic will bind the fabric feeding.
• Serge the elastic onto the fabric letting the Presser Foot stretch the elastic for
you.
FABRIC: Medium weight woven cotton 3” X 12”
12” of ½” nylon or cotton braid elastic
NEEDLES: 80/12 Ballpoint or 11/75 Stretch
THREAD: 2 cones of serger thread (Needles)
2 cones of Woolly Nylon (Loopers)
PRESSER FOOT: Elasticator