Bernina dcet 2500 - Manual (Page 85)


1999 BERNINA Of America
Section E - page 10
NARROW 2.5mm COVER STITCH
A
TTACHING
L
ACE
Instruction Manual pg.___
Feet-ures Unit ___pg.___
• Convert the serger from Overlock to Cover Stitch using the directions on
page__ in the Instruction Manual or on the Quick Reference card. Insert the
Center and Right Needles and turn the Stitch Selection Dial to “F”.
• Following the instructions on page ___ of your Instruction Manual, thread the
serger for a 3-Thread narrow (2.5mm) Cover Stitch.
• Use a Fabric Stiffener or Spray Starch to stabilize the fabric and lace.
• Position the lace on the right side of the fabric with the scalloped edge of the
lace even with the right edge of the fabric.
• Place fabric and lace under the Needles with the lace header positioned even
with the inside edge of the Left Floating Toe.
• Cover Stitch the lace to the fabric stopping with the Needles in the fabric.
• Turn the Handwheel away form you to raise the Needles to their highest position.
• Lift the Presser Foot and remove the fabric from under the Presser Foot.
• Trim the fabric from beneath the lace and mount the sample.
FABRIC: Medium weight woven cotton 3” X 6”
8” of 1” wide edging lace
NEEDLES: 80/12 Universal
THREAD: 3 cones of serger thread
PRESSER FOOT: Cover Stitch