Bernina dcet 2500 - Manual (Page 56)


1999 BERNINA Of America
Section C - page 18
C
ORDING
F
OOT
BIAS RUFFLE
Feet-ures Unit ___pg___
Bernette
 Advanced Guide Workbook pg.___
Instruction Manual for Cording Foot
• Thread the serger for a 3-thread Overlock stitch using the Center Needle.
Use the Woolly Nylon in the Upper Looper.
• Turn the Stitch Selection Dial to “C” on the Stitch Display Panel.
• Adjust the Stitch Length to 1.75
• Pull the Stitch Selection Lever/Rolled Hem towards you.
• Cutting Width should be at 2 (normal).
• Attach the Cording Foot.
• Raise the Presser Foot and swing it to the left.
• Following the direction in the Instruction Manual for Cording Foot, insert the
nylon fishing line through the Cord Guide.
• Return the Presser Foot to normal sewing position.
• Place the fabric under the Presser Foot and serge along one 8” edge stretching
the fabric edge as you sew.
• Return the Stitch Selection Lever/Rolled Hem to normal sewing position (away
from you). Return Stitch Length to normal.
• Trim and mount the sample.
FABRIC: Medium weight woven cotton 3” X 8” cut on the bias
NEEDLES: 80/12 Universal
THREAD: 2 cones of serger thread (Needle and Lower Looper)
1 cone of Woolly Nylon (Upper Looper)
Nylon fishing line 20 lb. test
PRESSER FOOT: Cording Foot