Bernina dcet 2500 - Manual (Page 57)


1999 BERNINA Of America
Section C - page 19
CORDING FOOT
WIRED EDGE FABRIC
Instruction Manual for Cording Foot
Feet-ures Unit ___pg.___
Bernette
 Advanced Guide Workbook pg.___
Serger Library – Simply Serging
Additions
• Thread the serger for a 3-thread Overlock stitch using the Center Needle.
Use the Woolly Nylon in the Upper Looper.
• Turn the Stitch Selection Dial to “C” on the Stitch Display Panel.
• Adjust the Stitch Length to 1.75
• Pull the Stitch Selection Lever/Rolled Hem towards you.
• Cutting Width should be at 2 (normal).
• Attach the Cording Foot.
• Raise the Presser Foot and swing it to the left.
• Following the direction in the Instruction Manual for Cording Foot, insert the
wire through the Cord Guide.
• Return the Presser Foot to normal sewing position.
• Place the fabric under the Presser Foot and serge along one 18” edge feeding
the wire through the Presser Foot as you sew.
• Use Wire Cutters to cut the wire.
DO NOT USE THE SERGER KNIVES.
• Repeat for the other 18” edge of the fabric.
• Return the Stitch Selection Lever/Rolled Hem to normal sewing position (away
from you). Return Stitch Length to normal.
• Secure the thread tails with a Seam Sealant. When the sealant is dry, cut the
thread tails. Use wire cutters to cut the wire.
• Tie the wired fabric into a bow.
• Mount the sample on the next page.
FABRIC: Medium weight cotton 3” X 18”
NEEDLES: 80/12 Universal
THREAD: 2 cones of serger thread
1 cone of Woolly Nylon
28 gauge floral wire
PRESSER FOOT: Cording Foot