Bernina dcet 2500 - Manual (Page 83)


1999 BERNINA Of America
Section E - page 8
5mm COVER STITCH TOP AND BOTTOM
Instruction Manual pg.___
• Convert the serger from Overlock to Cover Stitch using the directions on
page__ in the Instruction Manual or on the Quick Reference Card.
• Insert the Left and Right Needles.
• Turn the Stitch Selection Dial to “H”.
• Attach the Fifth Spool Holder.
• Following the instructions on page ___ of your Instruction Manual, thread the
serger for a 3-thread Cover Stitch with Jeans Stitch  in the Looper.
• Push the Wiper Activating Lever towards the Needle Bar.
• Lower the Wiper.
• Thread the Wiper using Jeans Stitch 
• Fold the fabric in half to 2½” X 6” and center the fabric under the Presser Foot.
• Cover Stitch the length of the fabric. Stop stitching with the Needles in the
fabric.
• Turn the Handwheel away from you to raise the Needles to their highest position.
• Lift the Presser Foot and remove the fabric from under the Presser Foot.
• Trim and mount the sample.
• Remove the thread from the Wiper Spool Pin.
• Disengage the Wiper and pull the Wiper Activating Lever away from the Needle
Bar to return the serger to 3-thread Cover Stitch.
FABRIC: Medium weight woven cotton 5” X 6”
NEEDLES: 90/14 universal
THREAD: 2 cones of serger thread (Needles)
2 spool of Jeans Stitch  (Looper and wiper)
PRESSER FOOT: Standard