Thread rolled hem, Attach the upper lopper converter, Press, trim, and mount the sample – Bernina dcet 2500 User Manual
Page 68
1999 BERNINA Of America
Section D - page 8
2-THREAD ROLLED HEM
Instruction Manual pg.___
Bernette
Advanced Guide Workbook Supplement I pg.___
Serger Library – Tips and Tricks
•
Attach the Upper Lopper Converter.
•
Following the directions found in the Instruction Manual on page___, thread
for a 2-thread Rolled Edge.
•
Turn the Stitch Selection Dial to “A”.
•
Set Stitch Length to 1.75.
•
Pull the Stitch Selection Lever/Rolled Hem towards you.
•
Adjust Cutting Width to 2 (normal).
•
Place the fabric under the Presser Foot and serge one 6” edge cutting off
about
1
/
8
” as you serge.
•
Return the Stitch Selection Lever/Rolled Hem to normal sewing position (away
from you).
•
Press, trim, and mount the sample.
FABRIC:
Batiste 3” X 6”
NEEDLES:
70/10 Sharp or Microtex
THREAD:
2 cones of Metrolene serger thread
PRESSER FOOT: Standard