Bernina dcet 2500 - Manual (Page 47)


1999 BERNINA Of America
Section C - page 9
INSIDE CORNER
Instruction Manual pg._____
Bernette
 Advanced Guide Workbook pg.____
• Thread the serger for a 3-thread Overlock stitch using the Center Needle.
• Turn the Stitch Selection Dial to “A” on the Stitch Display Panel.
O
PTION
I
• Cut an inside corner into the fabric.
• Snip into the corner ¼” (the width of the stitching).
• Serge until the Knife reaches the end of the cut.
• Touch the Needle Stop to lower the Needle into the fabric.
• Lift the Presser Foot and straighten the corner towards you.
• Lower the Presser Foot and continue serging.
• Trim and mount the sample on the next page.
O
PTION
II
• Rotate the Upper Knife up.
• Cut an inside corner into the fabric.
• Line up the left edge of the cut with the Lower Knife blade. Keep the edge of
the fabric even with the Lower Knife blade as you stitch.
• Serge for a few stitches. Touch the Needle Stop Button to lower the Needle
into the fabric.
• Fold the right side of dthe corner towards you at about a 45 ° angle.
• Serge 1 stitch into the cut corner. Touch the Needle Stop Button to lower
the Needle into the fabric.
• Lift the Presser Foot.
• Fold the serged edge down and to the left, angling the serged edge about 45 ° .
Pivot the fabric until the cut raw edge is even with the Lower Knife blade.
• Lower the Presser Foot and continue stitching.
• Use the Thread Cutter to cut the Thread Chain (the Upper Knife is disengaged).
• Return the Upper Knife to Cutting Position.
• Trim and mount the sample on the next page.
FABRIC: 2 pieces of firm woven cotton 3” X 4”
NEEDLES: 80/12 Universal
THREAD: 3 cones of serger thread
PRESSER FOOT: Standard