JLG X17J Operator Manual - Manual (Page 155)

9.2 E RROR MENU
Indicates correspondence between the double sensors, either (OK) or (FAULT).
The sensors are listed on different pages:
1 PREC ACCESS THE PREVIOUS PAGE
2 SUCC ACCESS THE SUCCESSIVE PAGE
9 EXIT
If the OK symbol is shown next to the sensor, this means that both elements on the same sen‑
sor are sending congruent information.
If the FAULT symbol is shown next to the sensor, this means that the elements on the same
sensor are sending incongruent information.
The last page of the error menu describes the error code relating to the battery charger
system, inverter and battery pack. Errors are indicated by the “spanner” icon in position 7 on
the remote control display.
If there are operating problems with the machine and the “spanner” icon is shown on the
display, contact Jlg’s service department.
9.3 O
PERATING HOURS MENU
Indicates the number of machine operating hours.
9.4 S
ETTINGS MENU
The items in this menu are not normally accessible.
9.5 J OYSTICK MENU
Displays the signal that each individual joystick sends to the main board.
X17JR0420113
BOOM LIFT MODELS X17J
JLG
151