JLG X17J Operator Manual - Manual (Page 52)

4.1.1 D ISPLAY
The display is used to view the status of the machine and the operating information neces‑
sary or useful for the operator.
When the machine and the radio control are switched on, the main control board of the
machine sends the radio control the information to be displayed.
This operation has a variable duration. Normally a few seconds are sufficient, however the
following download screen may appear on the display:
The display shows the information
transmission status through the
increasing number on the bottom
left side.
In this case about 20 minutes are needed to send all the information from the main board to
the radio control.
The machine cannot work during this period.
Do not stop the machine or operate it during this period.
4.1.1.1 D ISPLAY MAIN SCREEN
The radio control is switched on and off using the red button on the centre (see photo
To activate the radio control functions it is necessary to release the start button provided on
the device; at this point it will start and its status will appear on the display: charge level,
signal search, number of radio channel used, radio line with receiver on board the machine
X17JR0420113 48
BOOM LIFT MODELS X17J
JLG