JLG X17J Operator Manual - Manual (Page 27)

sis performed are in perfect working condition.
U
SE THE TYPE
‑
APPROVED AND CERTIFIED SAFETY HARNESSES
. B
EFORE WORKING AT HEIGHT
,
MAKE
SURE THAT THE SAFETY HARNESSES ARE CORRECTLY FASTENED AND CONNECTED TO THE ANCHORA ‑
GE POINTS ON THE BASKET
. T
HE USE OF HARNESSES IS COMPULSORY IN ACCORDANCE WITH LOCAL
LEGISLATION IN EACH INDIVIDUAL COUNTRY . IN CONTRIES WHERE THE LAW DOES NOT REQUIRE THE
USE OF SUCH SAFETY SYSTEMS
,
THE EMPLOYER AND
/
OR USER IS RESPONSIBLE FOR CHOOSING THE
SYSTEM TO BE USED
.
Safety valves and electrical system safety components
It is prohibited to modify and/or tamper with the safety and control valves on the main
hydraulic system and the settings of the electrical system.
The Constructor is not liable for injury to persons and damage to objects or the machine if
the standard setting of any hydraulic and electrical/electronic component is tampered
with.
Fire prevention
Keep the area around the motor clean, removing fragments of
wood, paper and other flammable products; clean any fuel
leaks as these may be a potential cause of fire.
Petrol is extremely flammable and explosive in particular con‑
ditions. Refuel in well ventilated areas and with the engine at
rest.
Avoid smoking and producing sparks in the refuelling and fuel storage area.
After refuelling, make sure to put back the cap correctly. Take care to avoid touching the
exhaust silencer when this is hot, i.e. with the machine running or soon after stopping the
engine.
Preventing damage caused by washing the machine
Do not direct high pressure jets towards the electrical compo‑
nents while washing the machine. Do not use chemical deter‑
gents or petrol that would damage the plastic parts and the
painting
B
EFORE WASHING THE MACHINE
,
ALWAYS REMEBER TO REMOVE THE
RADIO CONTROL AND CORRECTLY CLOSE THE RADIO CONTROL AND
EQUIPMENT CONNECTION SOCKETS LOCATED ON THE MACHINE
.
X17JR0420113
BOOM LIFT MODELS X17J
JLG
23
IMPORTANTE IMPORTANT