JLG X17J Operator Manual User Manual
Page 83
The complete closure and alignment is displayed by the arrows on the machine (SEE
PHOTO) and the display of the icon in position 6 on the radio control.
‑
The stabilisers must be lowered from the control position in the basket. Make sure that
visibility of the trajectory of each stabiliser is perfect before moving it.
‑
Select the engine/motor speed as required and check the selection on the display. Always
perform stabilisation at slow speed.
‑
Press and hold the automatic stabilisation button 7 (see the corresponding paragraph). If
the movements are selected with the machine not completely closed and aligned, an
error message will be shown on the display.
‑
Stabilisation will be completed when the machine is in horizontal position with toleran‑
ce of 1° and lifted at least 5 cm from the ground. Correct stabilisation will be confirmed
by the icon in position 5 on the display.
Always check the spirit level and make sure the slope is actually less than 1°.
X17JR0420113
BOOM LIFT MODELS X17J
JLG
79