JLG 4013PS Service Manual - Manual (Page 147)

9-7 3508PS, 3509PS, 3512PS, 3513PS, 4008PS, 4009PS, 4012PS, 4013PS, 4017PS, 40.8, 40.9
Electrical System
9.5 OPERATOR TOOLS
9.5.1 Resetting the Anti Theft Code
To reset the anti theft code:
1. Turn the engine to the ON position.
2. Press the "C" and "OK" buttons on the dash
simultaneously to enter the analyzer mode.
3. Scroll to "Access level code". Enter the code
"33271" to go into access level 2.
4. Scroll to and select the "Operator Tools" screen.
5. Scroll to and select the "Change Anti Theft Code"
screen.
6. Enter the current anti theft code.
Note: If a machine does not have an anti theft code set,
the default code is "00000".
7. Enter the new code.
9.5.2 Hardware Exchange
After the replacement of either the display or UGM
(Controller) the machine software will indicate a
Hardware Exchange fault. To correct this fault:
1. Turn the engine to the ON position.
2. Press the "C" and "OK" buttons on the dash
simultaneously to enter the analyzer mode.
3. Scroll to "Access level code". Enter the code
"33271" to go into access level 2.
4. Scroll to and select the "Operator Tools" screen.
5. Scroll to and select the "Perform Hardware
Exchange" screen.
6. Scroll to and select the proper screen for hardware
exchange. The screen will show either
"DISPLAY -> UGM" or "UGM -> DISPLAY". The new
component should be listed second.
9.5.3 Confirm Machine Service
To log the machine service into the software:
1. Turn the engine to the ON position.
2. Press the "C" and "OK" buttons on the dash
simultaneously to enter the analyzer mode.
3. Scroll to "Access level code". Enter the code
"33271" to go into access level 2.
4. Scroll to and select the "Operator Tools" screen.
5. Scroll to and select the "Confirm Machine Service"
screen.
6. If service is complete, press ENTER for YES.
Otherwise, press ESC for NO.
9.5.4 Review Service History
To view the last 15 machine service instances:
1. Turn the engine to the ON position.
2. Press the "C" and "OK" buttons on the dash
simultaneously to enter the analyzer mode.
3. Scroll to "Access level code". Enter the code
"33271" to go into access level 2.
4. Scroll to and select the "Operator Tools" screen.
5. Scroll to and select the "Review Service History"
screen.
6. Scroll through the screens to view the last 15 times
the machine was serviced.
9.5.5 Set Service Interval
To set the machine recommended service interval:
1. Turn the engine to the ON position.
2. Press the "C" and "OK" buttons on the dash
simultaneously to enter the analyzer mode.
3. Scroll to "Access level code". Enter the code
"33271" to go into access level 2.
4. Scroll to and select the "Operator Tools" screen.
5. Scroll to and select the "Set Service Interval" screen.
6. Enter a new service interval.