JLG 4013PS Service Manual - Manual (Page 224)

Electrical System
9-84 3508PS, 3509PS, 3512PS, 3513PS, 4008PS, 4009PS, 4012PS, 4013PS, 4017PS, 40.8, 40.9
COMMUNICATIONS 66XXX
CANBUS FAILURE –
PLATFORM
MODULE 662 1 Disregard any CAN messages with
the platform module source
addresses.
The PLATFORM OPTION is
configured as ENABLED and a
platform is detected as attached
and the UGM does not detect the
platform module on the CAN bus for
a period of 250msec.
Power cycled.
CANBUS FAILURE –
LOAD SENSING
SYSTEM MODULE 663 1, 14 Deactivate and inhibit the Lift Up
output.
Deactivate and inhibit the Lift Down
output.
Deactivate and inhibit the
Telescope Out output.
Deactivate and inhibit the
Telescope In output.
Deactivate and inhibit the Platform
Rotate Left output.
Deactivate and inhibit the Platform
Rotate Right output.
Deactivate and inhibit the Platform
Level Up output.
Deactivate and inhibit the Platform
Level Down output.
Deactivate platform module output
J2-19 Function Enable Relay.
Display the platform overloaded
screen on the cabin’s LCD.
Disregard any CAN messages with
platform module source addresses.
The PLATFORM STATION is active
and the PLATFORM OPTION is
configured as ENABLED and a
platform is detected as attached
and the LOAD SENSING menu
screen is not configured as NONE
and the UGM does not detect the
LSS module on the CAN bus.
Power cycled.
CANBUS FAILURE –
ENGINE
CONTROLLER 666 1, 3 Deactivate and inhibit output J2-26
Engage Starter.
The ENGINE CONTROL menu is
configured as ELECTRONIC and
the UGM does not detect the ECM
on the CAN bus.
Power cycled.
CANBUS FAILURE –
EXCESSIVE
CANBUS ERRORS 6613 1 N/A The UGM detects more than 500
Bus Off or more than 500 Bus
Passive conditions during a power
cycle or the UGM detects more than
22 Bus Off or more than 22 Bus
Passive conditions during a period
of 1 second.
Power cycled.
CANBUS FAILURE –
TRANSMISSION
CONTROLLER 6616 1 Only transmit messages that keep
the transmission in neutral.
The UGM does not detect the TCM
on the CAN bus when a
POWERSYNCRO transmission is
configured and an ENGINE
STOPPED or ENGINE RUNNING
state exists for a period of one
second.
Power cycled.
Message Fault
Code
Indicators Other Actions Taken Trigger for Fault Latch Until