JLG 4013PS Service Manual - Manual (Page 197)

9-57 3508PS, 3509PS, 3512PS, 3513PS, 4008PS, 4009PS, 4012PS, 4013PS, 4017PS, 40.8, 40.9
Electrical System
KEYPAD CANCEL
BUTTON – INVALID
SIGNAL 2340 1 Disregard all signal changes until
switch state transitions to LOW.
The UGM detects the keypad
CANCEL button is HIGH at power
up or for a period of 7 seconds or
longer.
Power cycled.
KEYPAD UP
BUTTON – INVALID
SIGNAL 2341 1 Disregard all signal changes until
switch state transitions to LOW.
The UGM detects the keypad UP
button is HIGH at power up or for a
period of 7 seconds or longer.
Power cycled.
KEYPAD DOWN
BUTTON – INVALID
SIGNAL 2342 1 Disregard all signal changes until
switch state transitions to LOW.
The UGM detects the keypad
DOWN button is HIGH at power up
or for a period of 7 seconds or
longer.
Power cycled.
BOOM ANGLE
SENSOR – NOT
CALIBRATED 2343 1 Assign a fixed boom angle value of
99×, as other functions will then
fault to safe conditions.
Display the fixed boom angle value
of ‘99’ on the operator’s cabin
display.
Derate the MAX LIFT UP in the
PERSONALITIES menu screen by
the LIFT UP DERATE value in the
Constant Data tables.
Ignore all hydraulic function
requests from the platform module.
The UGM detects no calibration has
been completed.
A valid boom
angle sensor
calibration is
completed.
BOOM ANGLE
SENSOR – OUT OF
RANGE HIGH 2344 1 Display the fixed boom angle value
of ‘99’ on the operator’s cabin
display.
Temporarily assign a fixed boom
angle value of 99×.
If a calibration is in progress, fail
boom angle sensor calibration
(“CALIBRATION: SENSOR
FAULT”).
Derate the MAX LIFT UP in the
PERSONALITIES menu screen by
the LIFT UP DERATE value in the
Constant Data tables.
Ignore all hydraulic function
requests from the platform module.
During operation or calibration, the
UGM detects a value at this input of
more than 4.4V.
Power cycled.
BOOM ANGLE
SENSOR – OUT OF
RANGE LOW 2345 1 Display the fixed boom angle value
of ‘99’ on the operator’s cabin
display.
Temporarily assign a fixed boom
angle value of 99×.
If a calibration is in progress, fail
boom angle sensor calibration
(“CALIBRATION: SENSOR
FAULT”).
Derate the MAX LIFT UP in the
PERSONALITIES menu screen by
the LIFT UP DERATE value in the
Constant Data tables.
²Ignore all hydraulic function
requests from the platform module.
During operation or calibration, the
UGM detects a value at this input of
less than 0.6V.
Power cycled.
Message Fault
Code
Indicators Other Actions Taken Trigger for Fault Latch Until