Barco RS232 - Manual (Page 21)

2. Basic Commands
2.4 Projector ON/OFF, Write
Description
Switching ON/OFF the projector
Command
Switching the projector ON
Command [0] \x65
Switching the projector OFF
Command [0] \x66
Example
Switches the projector ON
Transmit
Start \xfe
Projector address \x01
Command[0] \x65
Checksum \x66
Stop \xff
Receive (acknowledge)
Start \xfe
Projector address \x01
Command[0] \x00
Command[1] \x06
Checksum \x07
Stop \xff
2.5 Projector’s Status, Read
Description
Reads the Projector’s Status
Command
Command [0] \x67
Returned Data
Data [0] = unsigned byte
bit7 bit6 bit5 bit4 bit3 bit2 bit1 bit0
Not used Not used Cool down cycle
active = 0
inactive = 1
Not used Not used Not used Textbox
ON = 1
OFF = 0
Projector
ON = 1
OFF = 0
R5976884 RLM SERIES 04/04/2006 19