Barco RS232 - Manual (Page 79)

2. Basic Commands
2.38 Filmmode detection, Write
Description
Enables/disables the filmmode detection.
Command
Command [0] \x20
Command [1] \xa1
Data
Data [0] = byte type
byte value:
0 = OFF; 1 = ON
Example
Enables the Filmmode detection
Transmit
Start \xfe
Projector address \x01
Command[0] \x20
Command[1] \xa1
Data[0] \x01
Checksum \xc3
Stop \xff
Receive (acknowledge)
Start \xfe
Projector address \x01
Command[0] \x00
Command[1] \x06
Checksum \x07
Stop \xff
2.39 Filmmode detection, Read
Description
Reads whether the Filmmode detection is enabled or not
Command
Command [0] \x21
Command [1] \xa1
R5976884 RLM SERIES 04/04/2006 77