INFICON MDC-360 Thin Film Deposition Controller - Manual (Page 141)

MDC-360 DEPOSITION CONTROLLER
11-13 COMPUTER INTERFACE
46=None,
47=Dual
Control 1 * 68=Direct,
69=BCD,
70=Indiv, None
71=Manual
Drive 1
63=Inline,
64=Sngl Step,
65=Dbl Step
None * 60=Up,
61=Down,
62=Fast,
Feedback input type 1 8 =Individual,
9=BCD,
10=Single Home,
11=In Position,
12=No Feedback *
Rotator Delay 1 (0-99) seconds *
Total 6 ytes b
There are a total of four sensors ith 6 sensor for a total of 24 bytes.
ll 24 bytes are sent in the s age starting with sensor #1.
ple: To instruct the con to send the sensor setup parameter list the
omputer would send:
(235)
ensor setup parameter list is given above.
tion
Length (bytes) Allowable Range
w bytes per
A ame mess
troller Exam
c
Chr$(255)+Chr$(254)+Chr$(1)+Chr$(20)+Chr$(0)+Chr$
22. Receive sensor setup (Code #21)
ing sensor setup parameters into Instructs the controller to enter the incom
memory. A description of the s
23. Send Input setup (Code #22)
Instructs the controller to send the Input parameter list for Input #n. A descrip
of the Input parameter list is as follows:
Parameter Name
Input # 1 (0-15)
Type 1 0,255
Name 16 All ASCII Characters
I/O Card# 1 1-2
Input True Level 0 Bit 7 of Card# (0 = Low,
1=High)
Input Pin# 1 30-37
bytes Total 20