7 process data transfer, Process data transfer, Process data transfer 7 – Lenze E82ZAFPC010 User Manual
Page 43: 7process data transfer
Process data transfer
7
l
43
EDS82ZAFPC010 EN 4.0
7
Process data transfer
PROFIBUS transmits parameter data and process data between the host (master) and the
controllers connected to the bus (slaves). Depending on their time−critical nature, the data
are transmitted via different communication channels.
ƒ
Process data are transmitted via the process data channel.
ƒ
Process data serve to control the drive controller.
ƒ
The transmission of process data is time−critical.
ƒ
Process data are cyclically transferred between the host and the controllers
(continuous exchange of current input and output data).
ƒ
The host can directly access the process data. In the PLC, for instance, the data are
directly assigned to the I/O area.
ƒ
With the function module a maximum of 10 process data words (16 bits/word) can
be exchanged in each direction.
ƒ
Process data are not stored in the controller.
ƒ
Process data are, for instance, setpoints, actual values, control words and status
words.
)
Note!
Observe the direction of the information flow!
ƒ
Process input data (Rx data):
– Process data from controller (slave) to host (master)
ƒ
Process output data (Tx data):
– Process data from host (master) to controller (slave)