Lenze 8240 HVAC Series - Manual (Page 66)

Configuration
7-2 UOOuhäáã~_^NMMO
7.2 Code table
How to read the code table:
Column Abbreviation Meaning
Code C013 Code C013
D
The parameter of the code can be different in PAR1 and PAR2.
D
The parameter value is accepted immediately (ONLINE).
C009*
D
The parameter value of the code is always the same in PAR1 and PAR2, but is
always displayed in PAR1.
C001 ¿
D
The parameter value of the code will be accepted after pressing SH+PRG.
[C002]
D
The parameter value of the code will be accepted after pressing SH+PRG but
only if the controller is inhibited.
Name
820X
Name of the code.
Unit-specific setting possibilites (here for 820X).
Without unit designation the code is valid for all unit types.
Lenze Factory setting of the code
* The column ”Important” contains further information
Selection 1 {1 %} 99 Min. value {Steps/Unit} Max. Value
Info - Meaning of the code
IMPORTANT - Additional, important explanation of the code
Code Name Possible settings IMPORTANT
Lenze Selection Info
C001 ¿ Operating mode -0- -0- Setpoint selection via term. 8
Control via terminals
Parameter setting via 8201BB
-1- Setpoint selection via 8201BB or via
LECOM
Control via terminals
Parameter setting via 8201BB
-2- Setpoint selection via term. 8
Control via terminals
Parameter setting via LECOM
-3- Setpoint selection via LECOM
Control via LECOM
Parameter setting via LECOM
[C002]* Parameter set -0- -0- Function executed
-1- Overwrite PAR1 with factory setting
-2- Overwrite PAR2 with factory setting
-3- Overwrite PAR1 and PAR2 with the data of
the operating module
-4- Overwrite PAR1 with the data of the
operating module
-5- Overwrite PAR2 with the data of the
operating module
-6- Transmit PAR1 and PAR2 to the operating
module
-7- Overwrite PAR1, PAR2 and the
unit-dependent data (C016, C036, C088,
C091) with the data of the operating
module.
Show/Hide Bookmarks