Lenze 8240 HVAC Series - Manual (Page 70)

Configuration
7-6 UOOuhäáã~_^NMMO
Code IMPORTANT Possible settings Name Code IMPORTANT
Info Selection Lenze
Name
C023 I
max
limit
generator mode
80 30 {1 %} 150 The current-limit
controller for
operation in
generator mode is
not active at 30 %.
C026* Offset adjustment
analog input
0.00 -10.00 {0.01 V} 10.00
C027* Scaling factor of
analog input
100.0 -200.0 {0.1 %} 200.0
C034 ¿ Master current -0- -0- 0 to 20mA /
0 to 5V / 0 to 10V
-1- 4 to 20mA
C035* ¿ Selection DC brake -0- -0- Selection of brake voltage under C036
-1- Selection of brake current under C036
C036 Voltage for DC
brake
* 0 {0.02 %} 150 * depends on the unit
C037 JOG value 1 20.00 -480.00 {0.02Hz} 480.00
C038 JOG value 2 30.00 -480.00 {0.02Hz} 480.00
C039 JOG value 3 40.00 -480.00 {0.02Hz} 480.00
C040 Controller enable * -0- Controller inhibited
-1- Controller enabled
* see Operating
Instructions 2102
C043 TRIP reset * -0- No current fault
-1- Current fault
* see Operating
Instructions 2102
C046 Frequency setpoint * -480.00 {0.02 %} 480.00 * see Operating
Instructions 2102
C047* Torque setpoint
I
max
limit value
Only display
D
C005 = 4, 5
- Torque setpoint
D
C005 =
1, 2, 3, 6, 7
- I
max
limit
value (C022)
C049* Additional setpoint Only display
D
Only when
C005 = 1, 2
C050* Output frequency Only display
C051* Actual PID
controller value
Only display
C052* Motor voltage Only display
C053* DC-bus voltage Only display
C054* Motor current Only display
C056* Unit load Only display
C061* Heat sink
temperature
Only display
C070 Gain
PID controller
1.00 0.00 {0.01} 300.00 0.0 = P-component
inactive
C071 Integral action time
PID controller
100 10ms 9999s 9999s = I-componen
t inactive
C072 Differential
component
PID controller
0.0 0.0 {0.1} 5.0 0.0 = D-component
inactive
C074 Influence PID
controller
0.0 0.0 {0.1 %} 100.0
Show/Hide Bookmarks