Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 261)

L-force | PLC Designer
Menu Commands sorted by Categories

DMS 4.1 EN 03/2011 TD29 259
Zoom Buttons:
Use this buttons for changing the zoom factor so that the shared time axis is scaled up
or down. Use the third button to reset the factor so that the entire CNC path is visible
again. The same can be done with the Scroll Wheel while pressing the Ctrl key, or key +
and key - while pressing the Ctrl key
Axis:
Use the pull-down menu to select a space axis. Select between X, Y, Z, A, B, C, A1(P),
A2(Q), A3(U), A4(V), A5(W), A6 and Path. The special axis 'Path' will show the position
on the path and the path velocity, acceleration and jerk.
Cycle time [µs]:
Change the cycle time with the pull-down menu or by editing. This value is used as
input dwIpoTime of the function block SMC_INTERPOLATOR.
Velocity mode:
Select between trapezoid or sigmoid. This value is used as input iVelMode of the
function block SMC_INTERPOLATOR.