Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 645)

L-force | PLC Designer
General Editors

DMS 4.1 EN 03/2011 TD29 643
13.3.2 CNC Table Editor
In the table editor the path elements are listed in a table. The columns of the table are
configurable in sequence and visibility in the CNC Settings in the Table editor tab.
Abb. 335 CNC program in table view
General
By click in the table editor the focus of marked row is highlighted in light blue and the
selected table entry will be indicated by a thin blue frame in addition. The associated
path element becomes red with a blue start point. By click in the graphic editor the
currently selected element path is displayed red colored with a blue start point, while
the corresponding row in the table entry is highlighted in light gray. The usability or
the column depends on the element type. A column with no use is crosshatched and
empty. The find and replace functionality is not supported.