Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 405)

L-force | PLC Designer
Menu Commands sorted by Categories

DMS 4.1 EN 03/2011 TD29 403
12.22.10 Start
Symbol:
This command (category Online) starts the application program on the device (PLC).
If the command is called from the Online menu, the currently active application will be
concerned. If the command is called from the context menu when an application
object is selected in the device tree, then the selected application will be affected, no
matter whether it is set active.
12.22.11 Stop
Symbol:
This command (category Online) stops the application program on the device (PLC).
If the command is called from the Online menu, the currently active application will be
concerned. If the command is called from the context menu when an application
object is selected in the device tree, then the selected application will be affected, no
matter whether it is set active.
12.22.12 Single Cycle
This command (category Online) will process one cycle of the currently active
application.