Lenze PLC Designer PLC Designer (R3-1) - Manual (Page 553)

L-force | PLC Designer
Menu Commands sorted by Categories

DMS 4.1 EN 03/2011 TD29 551
CAM
The CAM tab serves to specify the global settings of the CAM, that is its dimensions, its
period and continuity requirements.
Abb. 300 Properties editor: CAM
Dimensions:
Master start / end position: Start and end position of the master define the set of
master values and thus the scale of the horizontal axis of the CAM. The default
settings are thought of in arc degrees and thus adjusted to 0 and 360.
Slave start / end position: The associated slave positions are determined by the CAM-
defining mapping, but the cutout displayed by the graphs, that is the scale of the
vertical axis, may be specified by the minimal and maximal value of the slave display.