Safety precautions – Rockwell Automation 20-COMM-I Interbus Adapter User Manual
Page 12
1-4
Getting Started
Please read the following safety precautions carefully.
Safety Precautions
!
ATTENTION:
Risk of injury or equipment damage exists. Only
personnel familiar with drive and power products and the associated
machinery should plan or implement the installation, start-up,
configuration, and subsequent maintenance of the product using a
Interbus adapter. Failure to comply may result in injury and/or
equipment damage.
!
ATTENTION:
Risk of injury or death exists. The PowerFlex drive
may contain high voltages that can cause injury or death. Remove all
power from the PowerFlex drive, and then verify power has been
removed before installing or removing a Interbus adapter.
!
ATTENTION:
Risk of equipment damage exists. The Interbus adapter
contains ESD (Electrostatic Discharge) sensitive parts that can be
damaged if you do not follow ESD control procedures. Static control
precautions are required when handling the adapter. If you are
unfamiliar with static control procedures, refer to Guarding Against
Electrostatic Damage, Publication 8000-4.5.2.
!
ATTENTION:
Risk of injury or equipment damage exists. If the
Interbus adapter is transmitting control I/O to the drive, the drive may
fault when you reset the adapter. Determine how your drive will
respond before resetting an adapter.
!
ATTENTION:
Risk of injury or equipment damage exists.
Parameters 6 - [Comm Flt Action]
lets you determine the action of
the adapter and connected PowerFlex drive if communications are
disrupted. By default, this parameter faults the PowerFlex drive. You
can set this parameter so that the PowerFlex drive continues to run.
Precautions should be taken to ensure that the setting of this parameter
does not create a hazard of injury or equipment damage.
!
ATTENTION:
Risk of injury or equipment damage exists. When a
system is configured for the first time, there may be unintended or
incorrect machine motion. Disconnect the motor from the machine or
process during initial system testing.
20COMM-UM007A-EN-P.book Page 4 Tuesday, January 22, 2002 10:52 AM