Applying power – Rockwell Automation 20-COMM-I Interbus Adapter User Manual
Page 22
2-6
Installing the Adapter
1. Close the door or reinstall the cover on the drive. Key status
indicators can be viewed on the front of the drive after power has
been applied.
Note: Interbus compliance requires different LED functions than what is
normally displayed on the front of the drive (Port, Mod, Net A, and Net
B Leds). LED labels are provided with the adapter for application to the
drive cover.
2. Apply power to the PowerFlex drive. The adapter receives its power
from the connected drive. When you apply power to the product for
the first time, the status indicators should be green or off after
initialization. Refer to
for more
information.
3. Apply power to the master device and other devices on the network.
Applying Power
!
ATTENTION: Risk of equipment damage, injury, or death exists.
Unpredictable operation may occur if you fail to verify that parameter
settings and switch settings are compatible with your application.
Verify that settings are compatible with your application before
applying power to the drive.
20COMM-UM007A-EN-P.book Page 6 Tuesday, January 22, 2002 10:52 AM