Rockwell Automation 20-COMM-I Interbus Adapter - Manual (Page 33)

Chapter
4
Configuring the Interbus Scanner
Interbus scanners are available from several manufacturers, including
SST. Chapter 4 provides instructions on how to utilize Phoenix Contact
CMD software to configure the network on an SST scanner.
All examples in this manual are based on the following:
• SLC controller with a SST Interbus scanner (SST-IBS-SLC)
in slot 1.
• PowerFlex 70 at Device 1.0 / CR 2 (CR# is needed for PCP
commands).
• Power Flex 70 at Device 2.0 / CR 3 (CR# is needed for PCP
commands).
• Logic Command / Status, Reference / Feedback and Datalinks A-D
are enabled in the 20-COMM-I and mapped to network I/O.
• Phoenix Contact CMD software is used to configure the network.
This chapter describes the steps to configure a simple network like what
is featured in
Figure 4.1 .
Topic Page
Example Network 4-1
Using CMD Software to Configure the Network 4-4
Adapter Configuration Settings to use with Ladder Examples 4-3
PowerFlex 70 Settings to use with Ladder Examples 4-15
RSLogix 500 SST Interbus Scanner Configuration 4-15
Example Network
20COMM-UM007A-EN-P.book Page 1 Tuesday, January 22, 2002 10:52 AM