Rockwell Automation 20-COMM-I Interbus Adapter - Manual (Page 38)

4-6 Configuring the Interbus Scanner
5. When complete, the representation area will look as shown in
Figure 4.6 .
Figure 4.6 Example Interbus CMD Project
This provides useful information regarding the CMD project being
created:
• “PowerFlex 70 Interbus Demo” indicates what this project is for.
• “SLC 5/05” indicates the controller used.
• “Interbus_SLC_Demo” indicates that Interbus_SLC_Demo.RSS
is the associated RSLogix500 program used with this system.
6. To configure the PC Com Port that CMD will use to communicate
with the SST scanner, click on Options/Settings and then the Driver
tab.
7. Click on the Communication Path icon and then the Standard tab.
8. Select the type of port of communication path used. Typically, this is
“Serial Port” and “Com1” respectively, as shown in Figure 4.7 . Click
OK until you return to the main screen.
Figure 4.7 Selecting the Port Communication path.
20COMM-UM007A-EN-P.book Page 6 Tuesday, January 22, 2002 10:52 AM