Rockwell Automation 1772-LS_LSP,D17726.8.6 PROG/OPER MANUAL-MINI PLC-2/05 - Manual (Page 123)

Data Transfer File Instructions
Chapter 11
11-14
Load each position of file A with the following data:
POSITION 003 0879
POSITION 004 0162
POSITION 005 1982
POSITION 006 9715
POSITION 007 5761
Important: You do not have to enter data in each position. You can skip
position numbers.
[CANCEL COMMAND]
HEXADECIMAL DATA MONITOR
FILE TO FILE MOVE
POSITION: 007 Counter Addr: 200
File A: 400Ć 406
File Length: 007
File R: 500Ć 506
POSITION FILE A DATA FILE R DATA
001
002
003
004
005
006
007
1257
The file to file move rung is displayed.
The screen does not change.
Puts the processor in the run/program mode.
The screen does not change.
[SEARCH]
590
[DISPLAY]
1
0721
0879
0162
1982
9715
5761
1257
0721
0879
0162
1982
9715
5761
Notice that the data in file A transferred to file R.
Do not clear your processor memory. The next example edits this rung.
Editing in a Completed Rung
In this section, you will edit your file’s data in the hexadecimal data
monitor display.
The screen does not change. [SEARCH]
Puts the processor in the remote program mode. 592